Conversion GPL-GN
WARNING: The following conversion must be performed by authorized professionals when the oven is completely cold. Improper installation, adjustment, alteration can cause property damage or injury.
- Only use the components and parts supplied with the conversion kit
- Following the conversion, apply the new label on the product and check that the size of the nozzle corresponds to that shown on the label.
1 GAS KIT DISASSEMBLY
Remove the gas kit according to the instructions in the appropriate section of the manual.
2 REPLACEMENT OF THE MAIN NOZZLE
Unscrew the fixing screw (a) and remove the plate covering the nozzle (b). Unfasten the main nozzle (e) to the holder screw (d) by using an 11 mm spanner. Replace the nozzle with the spare part supplied in the kit and screw it back to the holder (d) without e tightening it.
During these operations, lock the nozzle holder to keep it from rotating.
3.1 REPLACEMENT OF THE PILOT NOZZLE.
Unscrew the fixing screw (h) of the pilot light tube and remove it.
3.2
Remove the tube (i) from the seat.
3.3
Remove the pilot nozzle (l) from the cone-like support (o) and replace it with the spare component supplied in the kit. Reassemble everything following the same steps in reverse order.
